I have First Officer Pro configured to "Start up Power Source" (GPU)
When the Pre Flight flow commences I observe the First Officer Switching on the the GPU and then I am informed that it will take 90 seconds for the GPU to start (I was not aware that it took 90 seconds to start the GPU) After 90 seconds I am informed that Ground Power has been established, however the "Ground Power Available" light does not come on and there is no ground power. The First Officer continues his procedure without any ground power.
The only way I can establish ground power is in the usual way using the FMS setup but I was expecting the First Officer to start the ground power as selected in the Configuration (GPU selected and saved)
Has the configuration become confused with the APU settings?
Last Edit: Feb 13, 2020 7:52:50 GMT -5 by clive6354
My two monitors are set at different resolutions (both above 100%)
Dragging the application window between both monitors does not change the size. Therefore, if you are able to prevent the application window from changing size by adding a few lines this would be appreciated.
I’ll upload new installer tonight that fixes your form issue. Would you mind confirming that it works? I’ll also take a look at the GPU problem. To be clear, is the for for NGX or NGXu?
The application window problem still exists. The window shrinks to an impossible size, very difficult to read.
When the GPU starts a message flags up "Problem detected with GPU" can you expain what is happening there?
When the IRS is setup, why are the switches set to ATT mode and not Align
I’m having a hard time duplicating the issue, which is why it’s take so long to fix. I haven’t had any other reports either. What I’m going to do next is put a border around the form. It won’t look pretty, but I’m hoping it will prevent resizing when connected. There’s something unique about your setup that I just can’t replicate.
Main monitor 3840 x 2160 Second Monitor 19280 x 1080
The application window shrinks as soon as the First Officer Pre Flight Flow commences (after the time delay for him to take his seat)
Although my two monitors are different resolutions, dragging the application window to either monitor does not make any difference. I have tested the application using only my main monitor and the application window still shrinks as described above
Have you noted my comments regarding the GPU informing me that there is a problem and also why the First Officer puts the IRS switches into ATT mode?
Last Edit: Feb 20, 2020 4:47:47 GMT -5 by clive6354
On starting from cold and dark, start the application, First Officer begins his PRE FLIGHT FLOW. Why does he set No 1 engine start selector switch to GRD and No 2 to CONT. When the First officer is starting engine 2 the engine selector switch goes from CONT to OFF. The first officer continues oblivious that there is something wrong. After No 1 engine is selected to GRD the procedure continues with a message that both engines are stabilised. BOTH ENGINES ARE OFF and the packs were not set correctly, can you give an explanation